FB2100 Flow Computer Instruction Manual
D301783X012
November 2023
24 Installation
Figure 2-9. Aluminum Enclosure Clamps
2.8. Mounting the Enclosure
You can mount the flow computer directly to a pole. You can also mount it on a wall or
panel.
Bolting Considerations
If the flow computer installation requires assembly of a process flange, manifold, or
flange adapters, follow these assembly guidelines to ensure a tight seal for optimal
performance characteristics of the flow computer.
Only use bolts supplied with the flow computer or sold by Emerson Energy and
Transportation Solutions as spare parts. Refer to the figure for common flow computer
assemblies with the bolt length required for proper flow computer installation.
EXPLOSION HAZARD: Ensure the area in which you perform this operation is non-
hazardous. Performing this operation in a hazardous area could result in an explosion.
Note
For all other manifolds, contact your local Emerson Sales office or Emerson Impact
Partner.
Bolts are typically carbon steel or stainless steel. Confirm the material by viewing the
markings on the head of the bolt and referencing the figure. If bolt material is not shown
in the figure, contact your local Emerson Energy and Transportation Solutions
representative for more information.
Figure 2-10. Transmitter with Coplanar Flange
To Next Page
Loading...
