Emerson FB2100 - Page 98

FB2100 Flow Computer Instruction Manual
D301783X012
November 2023
84 Operation
Note
When using the IR buttons, aim your finger at the round spot just below the arrow.
Table 4-1. Infrared (IR) Buttons on HMI Module
Button
Mode
Use
OR
Screen Saver

Tap once to move up or down one
item through list of parameters.
 Hold to stay on current parameter.
Data Entry

Tap (UP) once to move the cursor to
the previous character in the list or
(DOWN) once to move the cursor to
the next character in the list.
 Hold (UP) or (DOWN) to scroll more
quickly through the character list.
Idle Mode
Hold to wake the display (if screen is off)
Screen Saver
Log out (if logged on)
Data Entry

Tap once to move the cursor to the
left.
 Hold to perform action shown on
screen (such as “Hold to Accept”)
Data Entry

Tap once to move the cursor to the
right.
 Hold to perform action shown on
screen (such as “Hold to Cancel”)
Symbol(s) representing the status of a value may appear in the upper right of the
display, next to the description. Multiple symbols may display. If there are no data
quality issues, no symbols display.
Table 4-2. Symbols on Display
Symbol
Explanation
Alarm - The parameter value shown is in an alarm state (High Alarm,
Low Alarm, etc.)
Override - The parameter value shown is in override mode (i.e. a user
entered fixed value)
Fault - The parameter value shown is somehow invalid
Unverified - For parameter values that require additional validation
(beyond simple database min/max range checking, the parameter
value shown has not yet been validated by the firmware).