Operation and Display Panel
25 Liebert
®
GXT4
™
User Manual
3.4.2 Default Screen
Press any button in the START SUCCESSFUL screen to enter the default interface, shown in Figure 3-6.
In the default screen, the LCD shows the UPS model, output parameters, input parameters, battery
capacity with run time estimate and load percentage. The UPS operation mode (online /inverter, ECO,
Battery or Bypass) will be indicated by the LED indicators.
If no control button (ESC, Up, Down, Enter) is pressed for 2 minutes, the LCD will enter the screen saver
mode (backlight turns off). It will remain off until a control button is pressed.
Figure 3-6 Default screen
3.4.3 Main Menu Screen
Press the Enter button in the default screen to enter the MAIN MENU screen, as shown in Figure 3-7.
To select a submenu, press the Up or Down button to move the cursor to the required item, then press the
Enter button to enter its submenu or set its parameter.
Figure 3-7 Main Menu screen
NOTE
Values shown in the default screen will vary depending on installation
and configuration.
O/P: 120V 60HZ 11.7A
I /P: 120V 60HZ 13.1A
BATT: 100% 3MINS
LOAD: 100%
GXT4-UPS 3KVA
1 STATUS
2 CONFIGURATION
3 CONTROL
4LOG
5 ABOUT
6NETWORK
To Next Page
Loading...
