REPARATION
No supplied cables are used with these connections:
• Please purchase the necessary cables at your local store.
Before you connect:
e sure your antenna or ot
y
before plugging in the AC power cord
onnect the RF coaxial cable on
our home outlet to the
antenna in
cable TV signalcable TV signal
nce connections are completed, turn on the unit and begin
nitial setup. Channel scanning is necessary for the unit to
memor
uestion about the DTV’s antenna, visit
www.antennaweb.or
ass on these devices is 2,000MHz or 2GHz
the
RF coaxial cable from the antenna in
ou did use an antenna to receive analo
TV, it should also
work for DTV rece
tion. Outdoor or attic antennas will be more
effective than a set to
our cable service, contact the
.
Connection to Cable Receiver or
Satellite Box
se an HDMI or Component Video cables to connect the
HDMI or the Component Video Input jacks of the unit to the
HDMI or the Com
acks of the cable
receiver / satellite box
ou connect to the unit’s Com
Audio cables to the Analo
STEREO
PCM
COMPONENT VIDEO OUT
Pr/CrPb/CbY
AUDIO OUT
RL
ANT IN
HDMI OUT
*
cable receiver / satellite boxcable receiver / satellite box
cable TV signalcable TV signal
satellite dishsatellite dish
2, you can also use the HDMI jack on the Rear Panel
ox other than the HDMI or the Com
uired cables and connectin
methods of the cable receiver /
atellite box, or the availabilit
channel for the clear QAM ma
se an HDMI cable with the HDMI lo
eed HDMI cable is recommended for the better com
utlet after all the necessar
Do not connect the AC power cord to a power supply outside
he indicated voltage of this unit (AC 120V)
onnecting the AC power cord to a power supply outside of this
range may result in fi re or electrical shocks
me you plug in the AC power cord, no operations will be
performed for a few seconds. This is not a malfunction