Emerson Micro Motion 1600 - Page 18

4.2.2 Wire the mA Output
Wire the mA Output for nonhazardous installations.
Prerequisites
WARNING
Meter installation and wiring should be performed only by suitably-trained personnel
using the appropriate government and corporate safety standards.
Procedure
Wire to the appropriate output terminal and pins.
Figure 4-1: Internally-powered mA Output wiring
A
D
C
B
A. mA Output
B. Channel B
C. 820 Ω maximum loop resistance
Note
This resistor is normally built into the signal device (d). This resistor is not used for HART
communications.
D. Signal device
Figure 4-2: Externally-powered mA Output wiring
A
E
D
C
B
A. mA Output
B. Channel B
C. 5–30 VDC (maximum)
D. See Figure 4-3
E. Signal device
Wiring the channels Installation Manual
March 2022 00825-0100-1600
18 Micro Motion 1600 Ethernet Transmitters