5. Configure the IP address.
a) Navigate to one of the following screens:
From the display From ProLink III
Go to Menu → Configuration →
Ethernet Settings → Network Settings
→ IP address.
Go to Device Tools → Configuration →
Network Settings.
b) Set the IP address to 192.168.192.x, where x is something other than 0, 1,
or 168.
6. Configure the subnet mask.
a) Navigate to one of the following screens:
From the display From ProLink III
Go to Menu → Configuration →
Ethernet Settings → Network Settings
→ Subnet Mask.
Go to Device Tools → Configuration →
Network Settings.
b) Set the subnet mask to 255.255.255.0.
7. Configure the printer type.
a) Navigate to one of the following screens:
From the display
From ProLink III
Go to Menu → Configuration → Printer
→ Printer Type.
Go to Device Tools → Configuration →
Printer and Tickets.
b) Verify that the IP address is 192.168.192.168.
6.3 Reset the interface settings
Use this procedure if you forgot the IP address of your printer and need to reset the default
(192.168.192.168).
Procedure
1. Turn off the printer and close the roll paper cover.
2. If the connector cover is attached, remove the cover.
3. Hold down the status sheet button on the back of the printer while turning on the
printer.
A message displays indicating that resetting is being performed.
4. Release the status sheet button to reset the printer settings to default.
Important
Do not turn off power until the process is complete.
Set up the printer Installation Manual
March 2022 00825-0100-1600
32 Micro Motion 1600 Ethernet Transmitters
To Next Page
Loading...
