Figure 4-9: Externally-powered DO wiring
A. Discrete Output
B. Channel B
C. 3–30 VDC (maximum)
D. 500 mA current (maximum)
E. Counter
4.2.5
Wire the I/O channel using an M12-terminated cable
(optional)
Use this procedure if you are using an M12-terminated cable to wire the I/O channel.
Prerequisites
Obtain an A-coded M12-terminated cable.
Procedure
1. Attach the M12-terminated cable to the configuration I/O connector on the 1600
transmitter.
2. Attach the other cable end using the pinouts described in the following table.
Figure 4-10: M12-terminated cables to the configuration I/O
Table 4-1: Cable end I/O pinouts
Pin
identification
Wire color Outputs on terminal Signal name
Pin 1 Brown Pin3 VDC +
Wiring the channels Installation Manual
March 2022 00825-0100-1600
22 Micro Motion 1600 Ethernet Transmitters
To Next Page
Loading...
