4.3.2 Wire the Ethernet I/O using M12-terminated cables
(optional)
Prerequisites
Obtain one D-coded M12-terminated Ethernet cable.
Procedure
1. Attach the M12-terminated Ethernet cable to the Ethernet I/O connector on the
1600 transmitter.
Figure 4-11: M12-terminated cables to the Ethernet I/O
2. Attach the other cable end using the pinouts described in the following table.
Table 4-2: M12 Ethernet I/O pinouts
Pin
identification
Wire color Outputs on RJ45 Signal name
Pin 1 Orange/White Pin1 TDP1/RDP2
Pin 2 Green/White Pin 3 RDP1/TDP2
Pin 3 Orange Pin 2 TDN1/RDN2
Pin 4 Green Pin 6 RDN1/RDN2
Wiring the channels Installation Manual
March 2022 00825-0100-1600
24 Micro Motion 1600 Ethernet Transmitters
To Next Page
Loading...
