Emerson Micro Motion 5700 - Wire the Ma Output

2. Confirm which transmitter channels are activated, or ON, and identify the type of
configuration you will be wiring to based on the options available.
Figure 4-1: Activated channel identification
A
A. Key to identify the activated input/outputs
3. Record the channel and wiring configuration on the label provided inside the
transmitter housing cover.
Figure 4-2: Channel and wiring configurations label
4.3 Wire the mA Output
Use this section to wire the mA Output in explosion-proof, nonincendive, or nonhazardous
installations.
Important
Meter installation and wiring should be performed only by suitably-trained personnel.
4.3.1
Wire the mA Output (internally powered)
Procedure
Wire to the appropriate output terminal and pins.
Wiring the channels Installation Manual
February 2020 MMI-20027478
24 Micro Motion 5700 Transmitters with Configurable Outputs