Emerson Micro Motion

8 Transmitter operation
Topics covered in this chapter:
• Record the process variables
• View process variables
• View and acknowledge status alerts
8.1 Record the process variables
Micro Motion suggests that you make a record of specific process variable measurements,
including the acceptable range of measurements, under normal operating conditions. This
data will help you recognize when the process or diagnostic variables are unusually high or
low, and may help you diagnose and troubleshoot application issues.
Procedure
Record the following process and diagnostic variables, under normal operating conditions.
Variable
Measurement
Typical average Typical high Typical low
Line Density
Line Temperature
Sensor Time Period
Pickoff Voltage
Drive Gain
8.2 View process variables
Process variables provide information about the state of the process fluid, such as flow
rate, density, and temperature, as well as running totals. Process variables can also provide
data about flowmeter operation, such as drive gain and pickoff voltage. This information
can be used to understand and troubleshoot your process.
• View process variables using the display (Section 8.2.1)
• View process variables and other data using ProLink III (Section 8.2.2)
• View process variables using the Field Communicator (Section 8.2.3)
8.2.1 View process variables using the display
View the desired process variable(s).
Transmitter operation
Configuration and Use Manual 105