Emerson Rosemount 2410 - Optional Configuration and Settings; Change Baud Rate

5 Optional configuration and settings
5.1 Engineering units
The tank hub automatically converts all measurement values to the correct engineering
unit. No additional configuration is needed.
5.2 Average Liquid Temperature
The normal tank hub configuration is sufficient, no additional configuration is needed.
5.3 Observed density
The normal tank hub configuration is sufficient, no additional configuration is needed.
5.4 Free water level
The normal Rosemount 2240S Temperature Transmitter configuration is sufficient, no
additional configuration is needed.
5.5 Change baud rate
The tank hub modem supports Sakura bus baud rate between 300 and 5000 baud. The
modem detects the baud rate automatically when receiving data on the Sakura bus.
The detected baud rate value can be read from input register SecondaryBus-ExtBaudrate
(1255).
The bus baud rate can be changed by using holding register Sakura_BaudRate (1217), see
Table 5-1.
Table 5-1: Configure Sakura Bus Baud Rate
Holding register Register
number
Default
value
Description
Sakura_BaudRate 1217 0 The automatic baud rate detection is enabled by
default (recommended). To change the bus baud rate,
write the desired baud rate to the value field.
Figure 5-1 shows an example where holding register Sakura_BaudRate (1217) is set to
value 0. The automatic baud rate detection is enabled.
Manual Supplement Optional configuration and settings
00809-0800-2410 August2023
Emerson.com/Rosemount 21