Emerson Vilter VSS - Oil Filter Element Removal (for 3111 A Oil Filter Housing); Oil Filter Element Removal (for 3110 A or 3112 A Oil Filter Housing); Oil Pump Strainer Screen Removal and Service

5 – 14
Section 5 • Maintenance/Service
VSS/VSM/VSH/VSSH • Installation, Operation and Maintenance Manual • Emerson • 35391SD
Oil Filter Element Removal
(For 3111A Oil Filter Housing - See Figure 5-9)
NOTICE
Dispose of used oil in an appropriate manner following
all Local, State and Federal laws and ordinances.
9. Remove locking ring and lter housing from head
assembly.
10. Remove lter element from internal port of head
assembly.
11. Clean lter element connection area of head as-
sembly and interior of lter housing.
12. Remove (head-to-housing) O-ring from inside of
lter head. Discard O-ring.
Oil Filter Element Removal
(For 3110A OR 3112A Oil Filter Housing - See
Figure 5-10)
13. Remove oil lter housing cover and O-ring from oil
lter housing. Discard O-ring.
14. Remove lter element from internal port of head
assembly.
15. Clean lter element connection area of head as-
sembly and interior of lter housing and cover.
Oil Pump Strainer Screen Removal and Service
16. Remove four bolts and strainer cover from strainer
body.
17. Remove screen from strainer body.
18. Clean screen and interior of strainer body
19. Inspect screen for damage, replace if required.
Figure 5-9. Filter Assembly and Oil Strainer Drain Valve (VPN 3111A Oil Filter Housing Shown)
View Rotated 180˚
Oil Strainer
Drain Valve
Oil Filter
Outlet Valve
Temperature
Gauge
OIL INLET FROM
OIL COOLER
OIL OUTLET TO
COMPRESSOR
Temperature
Element
Oil Filter Head
Assembly
Oil Filter Mounting
Bracket
Oil Filter
Drain Valve
Oil Filter Element
Locking Ring
Oil Inlet
Connection
Oil Outlet
Connection
Oil Filter
Housing
Plug