© 2013 EMP, Inc 2
Engineered Machined Products Inc.
2701 North 30
th
Street
Escanaba, Michigan 49829
Phone: 906-789-7497
www.emp-corp.com
Service@emp-corp.com
Product Overview
The WP29 and WP32 are electrically powered fluid pumps available in 12 volt DC and 24 volt DC
configurations. The pump is available with carbon steel, or stainless steel shafts for fluid compatibility. Proper
installation of the pump will help ensure the performance and reliability of the electric pump while reducing the
risk of damage to other components in the system.
This document provides a check list to confirm that the pump and the installation of the pump fall within the
hardware and operational capabilities of the pump. If there are parameters outside the normal application,
additional information will be required for EMP Engineering to approve the installation or warranty will be void.
Use the Installation Approval check sheet located in Appendix B to submit
installation information to EMP for approval.
The information contained in this manual is updated periodically. While great care is taken in compiling the information contained in this manual,
Engineered Machined Products, Inc. cannot assume liability for losses of any nature arising from any errors and/or omissions.
The information and specifications contained throughout this manual are up to date at the time of publication. Engineered Machined Products, Inc.
reserves the right to change the content of this manual at any time without notice.
To Next Page
Loading...
Need help?
General
