Safety
© 2013 EMP, Inc 4
Safety
Warnings, Cautions & Notes
Three types of headings are used in this manual to stress your safety and safe operation of the WP29.
They appear in the text as follows:
WARNING:
THIS SYMBOL IS USED TO MAKE YOU AWARE OF AN UNSAFE CONDITION, HAZARD, OR PRACTICE THAT
CAN RESULT IN PERSONAL INJURY OR DEATH.
CAUTION:
THIS SYMBOL IS USED TO ALERT YOU TO A CONDITION OR PRACTICE THAT CAN CAUSE DAMAGE TO
THE WP29 AND WP32 OR THE VEHICLE, OR BOTH.
NOTE: Is used to provide additional information that requires special attention by the technician.
Product Safety Warnings
EMP cannot anticipate every possible circumstance that might involve a potential hazard. The safety messages in this
document, in related manuals, and on the product are therefore not all inclusive. If a tool, procedure, work method, or operating
technique that not specifically recommended by EMP is used, you must satisfy yourself that it is safe for you and for others. You should
ensure that the product will not be damaged or be made unsafe by the operation, maintenance, or repair procedures that you choose.
Ensure that all safety message and information messages are read and understood before installation, maintenance, or any
repairs are performed. The person who services the product may be unfamiliar with many of the systems on the product. It is
important to use caution when service work is performed. Knowledge of the vehicle system and operation are important before the
removal or disassembly of any component.
Make sure the vehicle is in neutral, the parking brake is set, and the wheels are blocked before doing any work or diagnostic
procedures on the WP29 and WP32, or vehicle.
Disconnect the main negative battery cable and/or switch the battery disconnect switch to the OFF position first before
installation or servicing.
Use extreme caution when working on systems under pressure (i.e. coolant, hydraulic fluids, air, etc…)
Make sure the work area is ventilated and well lit.
Make sure charged fire extinguishers are in the work area.
Reinstall all safety guards, shields, and covers after servicing the vehicle.
Make sure all tools, parts, and service equipment are removed from the engine compartment and vehicle after all work is done.
Do not apply power to the pump without fluid since most pumps are programmed to start when power is applied and the pump
seal will be damaged if run dry.
If CAN or Serial TTL control is not used the 6 pin DTM connector must be blocked off to prevent entry of water or dirt which will
result in damage to the pump. A block off plug EMP P/N 3250001030 can be purchased or one can be fabricated from the Deutsch
parts listed in the table on page 12
To Next Page
Loading...
Need help?
General
