EasyManuals Logo

EMP WP29 Installation Manual

EMP WP29
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
Appendix B, EMPower Connect Service Tool
© 2013 EMP, Inc 27
Product Installation Questionnaire
Input
Met?
Reference Document(s)
and/or
Comments
Reference
Section
Input Requirement
Yes
No
Specifications -
Performance
Do the flow and pressure curves match the system
requirements?
Specifications -
Limitations
Is the maximum system fluid temperature (at the pump
inlet) less than or equal to 95°C?
Specifications -
Limitations
Is the maximum ambient temperature less than or
equal to 95°C?
Specifications -
Limitations
Is the minimum system fluid temperature (at the pump
inlet) greater than or equal to -40°C?
Specifications -
Limitations
Is the minimum ambient temperature greater than or
equal to -40°C?
Specifications -
Limitations
Is the application vibration enveloped by the EMPTS009
profile?
Specifications -
Limitations
Is the pump's mounting bracket .187" thick or greater?
Does the bracket natural frequency exceed 150 Hz (with
the pump mounted)?
Specifications -
Limitations
Are any bracket resonances or other audible
abnormalities observed when the pump is run through
the range of operating speeds?
Specifications -
Limitations
Is the pump located where there is a minimum 13mm
(1/2 inch) clearance to ensure no rubbing or
interference?
Specifications -
Limitations
Is the pump located away from external heat sources
and direct road spray?
Specifications -
Limitations
If pump is exposed to external heat and road spray, is
proper shielding in place to protect the pump?
Specifications -
Limitations
If the pump is exposed to road spray, is the correct
pump orientation (horizontal/vertical) and part number
being used (severe service)?
Specifications -
Approved Fluids
Is the system fluid on the approved fluids list? Provide
fluid information and spec sheet.
Specifications -
Approved Fluids
Is the proper shaft material selected for the fluid used
in the application (stainless steel vs carbon steel)
Specifications -
Electrical
Does the application meet the voltage and current
requirements
Specifications -
Electrical
Is there a fluid level warning and/or switch to prevent
dry operation of the pump? List the type of system used
Specifications -
Electrical
Are the power and ground wires a minimum of 12 AWG
wire?

Other manuals for EMP WP29

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EMP WP29 and is the answer not in the manual?

EMP WP29 Specifications

General IconGeneral
BrandEMP
ModelWP29
CategoryWater Pump
LanguageEnglish

Related product manuals