Why does my Empire Paintball equipment shoot more than once from one trigger pull?
If your Empire Paintball equipment is firing multiple balls with a single trigger pull, it could be due to a low battery. Try replacing the battery with a fresh Duracell or Energizer brand alkaline 9V. Another possibility is that the trigger may need adjustment to ensure it has sufficient travel before and after the activation point.
What to do if my Empire Paintball equipment leaks constantly through the chamber?
Detailed list of the marker's model, caliber, air source, battery, and materials.
List of items provided in the package with the Empire AXE marker.
Explanation of the LED indicator for system status, battery life, and trigger pull.
Guidance on interpreting LED colors for battery status and replacement needs.
Procedure to power on the marker, including LED indications.
Steps to safely power down the marker and its automatic shut-off feature.
Instructions on how to correctly install the marker's barrel.
Pre-pressurization checks including safety gear and marker condition.
Procedure for connecting and pressurizing the marker with an air tank.
Crucial safety warning about eye and face protection during firing.
How the LED indicates trigger pull status.
Instructions for adjusting the marker's air pressure using the regulator screw.
Important notes regarding velocity adjustment and safety standards.
Explanation of the tournament lock feature and its activation.
How to enter and navigate the marker's settings and functions mode.
Note on how firing mode changes affect ROF and ramping parameters.
Important notes on trigger adjustment, loctite use, and potential issues.
Instructions for cleaning the exterior of the marker without water.
Guidance on cleaning and greasing internal components like the bolt guide assembly.
Tips for a smooth disassembly process and reassembly checks.
Procedure for removing and cleaning the marker's barrel.
Detailed steps for removing and reinstalling the bolt and bolt guide assembly.
Steps to detach the grip frame from the marker body.
Procedure for reattaching the grip frame, ensuring wire safety.
How to remove, clean, and reinstall the ball detents.
Steps to detach the regulator from the grip frame.
Procedure for reattaching the regulator assembly to the grip frame.
Steps to detach the air transfer plate from the marker body.
Procedure for reattaching the air transfer plate, including gasket and check valve.
Steps for safely removing and cleaning the sensor board.
Procedure for correctly reinstalling the sensor board into the marker.
Troubleshooting steps if the marker fails to power on.
Steps to diagnose and fix issues preventing the marker from firing.
Diagnosing and fixing constant air leaks from the marker chamber.
Troubleshooting double feeds or multiple shots from a single trigger pull.
Solutions for issues caused by dirty or worn ball detents.
Fixing leaks originating from the regulator's bottom plug.
Troubleshooting variations in the marker's projectile velocity.
Addressing velocity decrease during rapid firing sequences.
Fixing a stiff or difficult-to-operate regulator on/off lever.
Troubleshooting removal issues with the bolt guide assembly.
List of primary marker components, from set screws to air transfer tubes.
List of secondary marker components, from regulator mounts to detent assemblies.
Specific conditions and parts excluded from the limited lifetime warranty.
General| Marker Type | Electronic |
|---|---|
| Battery | 9V |
| Body Material | Aluminum |
| Air Source | HPA (High Pressure Air) |
| Barrel Thread | Autococker |
| Feedneck | Clamping |
| ASA | On/Off |
| Firing Modes | Semi-Auto |
To Next Page
