01 02 03 04 05
T
Changing the needle
position
These setting apply only to patterns 01-05. The pre-set position is
"3.5", center position. When you press the "–" stitch width
adjustment button, the needle position will move to the left.
When you press the "+" stitch width adjustment button, the
needle position will move to the right.
Changing the stitch
length
To shorten the stitch length, press the "–" stitch length
adjustment button. For a longer stitch length, press the "+" stitch
length adjustment button.
Generally speaking, the thicker the fabric, thread and needle, the
longer the stitch should be.
Zigzag
stitches
06 07 08 08
T A
Adjusting the stitch
width
The maximum zigzag stitch width for zigzag stitching is "7.0";
however, the width can be reduced on any patterns. The width
increases as you press the stitch width adjustment button from
"0.0-7.0".
Adjusting the stitch
length
The density of zigzag stitches increase as the setting of stitch
length approaches "0.3".
Neat zigzag stitches are usually achieved at "1.0-2.5".
Closed up zigzag stitches (close together) are referred to as a
satin stitch.
To Next Page
Loading...
