Empress Effects ECHOSYSTEM - Using Dual Delay Engines; Syncing Delay Times; Soloing an Engine

USING DUAL DELAY ENGINES
The Echosystem has two engines which can each run any
mode. You can route these engines in parallel, serial, or split
left/right.
When using dual engines, two mode LEDs light up. The bright
one is the mode whose controls are active. Press down on the
mode knob to toggle which mode is active.
SYNC DELAY TIMES BETWEEN ENGINES
Hold the tap stomp and press the engines button, and the
delay time from the bright mode will be sent to the dimmed
mode. Note: The delay time sent to the other mode is the time
you tapped (pre-ratio) and the dimmed mode will apply its
ratio to that tapped time. This makes it easy to have the modes
in sync at different ratios. Both modes must be set to tap
tempo to sync delay times.
SOLO AN ENGINE
When getting sounds while using dual engines, it can help to
mute the dimmed mode temporarily. Hold the shift button and
press down on the mode knob to solo the active mode. The
active mode LED will blink while solo’d. To return to normal
operation press the mode knob again.