CONTROL VOLTAGE (CV)
With CV control, the Echosystem responds to CV signals from 0
to 5 volts. Otherwise, the CV configuration works exactly like
the expression pedal configuration.
EXTERNAL TAP SWITCH
The Echosystem can be used with either a normally-open or a
normally-closed external switch. This switch operates like the
tap stompswitch, with the exception of loading presets.
MIDI
All the parameters of the Echosystem can be controlled via
control change messages. Its presets can be selected with
program change messages, and its tempo can be controlled
with MIDI clock messages.
To use MIDI with your Echosystem, you'll have to:
1. Connect the Empress Midibox (not included with the
Echosystem) using a ¼” patch cable to the control port. A
TRS cable is required to send MIDI out messages if you're
using the Echosystem to control other pedals.
2. Configure the pedal for MIDI control and set the MIDI
channel. See Advanced Configuration for instructions.
Choose a MIDI channel that won't conflict with other
devices in your MIDI rig.
To Next Page
Loading...
