Empress Effects ECHOSYSTEM - MIDI Control Change Messages: Parameters A-F; Modes, Delay Source, Time Controls; Parameter and Stomp Controls

MIDI CONTROL CHANGE MESSAGES REFERENCE
Echosystem
Parameter
CC#
Note:
Engine
A
Engine
B
Modes
100
109
The modes and sub-modes are
numbered starting from 0
(Digital = 0, Tape = 1, etc.) To
translate the modes and sub-
mode to a single number you
apply the following equation:
MIDI message value = (mode x
8) + sub-mode
Example: To load the 2nd tape
mode, you'd send a value of 9
with the CC message. (1x8) + 1.
Delay Source
101
110
0 - Knob, 1 - Local, 2- Global
Delay Time / Ratio
102
111
Sending a value 0 would be
equivalent to the knob
completely counterclockwise,
sending 127 is equivalent to
fully clockwise.
Mix
103
112
Volume
104
113
Feedback
105
114
Tone
106
115
Thing 1
107
116
Thing 2
108
117
Engage / Bypass
60
0 to bypass, 127 to engage
Recall Preset
11
Send preset # to load that
preset.
Simulate
Expression Pedal
10
0 to 127 as the sweep of the
expression pedal from heel to
toe.
Routing Mode
118
0 - Trails, 1 - Parallel, 2- Serial,
3 - Left/Right
Left Stomp - Tap
35