WARNING! This will overwrite your current presets and advanced
config settings and replace them with the factory presets and
default advanced config settings!
To restore the Echosystem to its factory settings, do the
following: while in the advanced configuration (see Entering
Advanced Configuration): press and release the stompswitches
in this order: Tap, Bypass, Tap, Bypass. Then the LEDs do a
dance. Now you can exit advanced configuration (see Exiting
Advanced Configuration).
POWERING THE ECHOSYSTEM
Go to www.empresseffects.com/power for a full list of
compatible power supplies.
Please Note: The Echosystem requires at least 300mA of
current to function properly. Any power supply rated at 9V DC,
supplying negative tip polarity ( ) and at least 300mA
of current should work.
To Next Page
Loading...
