Action: Select Deny Association to block access to the router, MAC addresses not listed will be
allowed to access the router. Select Allow Association to permit access to the router, MAC
addresses not lusted will be denied access to the router.
7 Advanced Setup
7.1 Firewall
User can enable or disable firewall feature of the ADSL router in the page.
Firewall: Select this option can automatically detect and block Denial of Service (DoS) attacts,
such as Ping of Death, SYN Flood, Port Scan and Land Attack.
SPI: Select this option to Enabled or Disabled the SPI feature. (NOTE:
If you enable SPI, all
traffics initiate from WAN would be blocked, including DMZ, Virtual Server, and ACL WAN side)
7.2 Routing
This table lists IP address of Internet destinations commonly accessed by your network.
When a computer requests to send data to a listed destination, the device uses the Gateway IP
to identify the first Internet router it should contact to route the data most efficiently. Select this
option will list the routing table information. You can press ADD ROUTE to edit the static route.
(As below screen)
50
To Next Page
Loading...
Need help?
General
