Endress+Hauser iTEMP TMT112 - Mounting the DIN Rail Transmitter; Post-Installation Check; 5 Electrical Connection

Electrical connection iTEMP TMT112
12 Endress+Hauser
4.2 Mounting the DIN rail transmitter
35mm
EN 50022
5
6
1.
2.
A0040216
4.3 Post-installation check
After installing the device, always run the following final checks:
Device condition and specifications Notes
Is the device undamaged (visual inspection)? -
Do the ambient conditions match the device specification (e.g. ambient temperature,
measuring range, etc.)?
See 'Technical data'
section →  26
5 Electrical connection
L
CAUTION
‣
Switch off the power supply before installing or connecting the device. Failure to observe
this may result in the destruction of parts of the electronics.