Endress+Hauser iTEMP TMT112 - Tool Symbols; Documentation

About this document iTEMP TMT112
6 Endress+Hauser
1.3.4 Symbols in graphics
Symbol Meaning Symbol Meaning
1, 2, 3,... Item numbers
1.
,
2.
,
3.
… Series of steps
A, B, C, ... Views A-A, B-B, C-C, ... Sections
-
Hazardous area
.
Safe area (non-hazardous area)
1.4 Tool symbols
Symbol Meaning
A0011220
Flat blade screwdriver
A0011219
Phillips head screwdriver
A0011221
Allen key
A0011222
Open-ended wrench
A0013442
Torx screwdriver
1.5 Documentation
Document Purpose and content of the document
Technical Information
TI00114R/09/EN
Planning aid for your device
The document contains all the technical data on the device and provides an
overview of the accessories and other products that can be ordered for the
device.
Brief Operating Instructions
KA193R/09/EN
Guide that takes you quickly to the 1st measured value
The Brief Operating Instructions contain all the essential information from
incoming acceptance to initial commissioning.
The document types listed are available:
In the Download Area of the Endress+Hauser Internet site: www.endress.com →
Download