iTEMP TMT112 Basic safety instructions
Endress+Hauser 7
1.6 Registered trademarks
• HART
®
Registered trademark of the HART
®
FieldComm Group
• Microsoft
®
, Windows NT
®
and Windows® 2000
Registered trademarks of Microsoft Corporation, Redmond, USA
2 Basic safety instructions
2.1 Requirements for the personnel
The personnel for installation, commissioning, diagnostics and maintenance must fulfill the
following requirements:
‣
Trained, qualified specialists must have a relevant qualification for this specific function
and task
‣
Are authorized by the plant owner/operator
‣
Are familiar with federal/national regulations
‣
Before beginning work, the specialist staff must have read and understood the instructions
in the Operating Instructions and supplementary documentation as well as in the
certificates (depending on the application)
‣
Following instructions and basic conditions
The operating personnel must fulfill the following requirements:
‣
Being instructed and authorized according to the requirements of the task by the facility's
owner-operator
‣
Following the instructions in these Operating Instructions
2.2 Designated use
The unit is a presettable temperature transmitter for resistance thermometer (RTD),
thermocouple (TC) as well as resistance and voltage sensors. The unit is constructed for
mounting on a DIN rail.
The manufacturer is not liable for damage caused by improper or non-designated use.
Separate Ex documentation is part of this operating manual, for measurement systems in
hazardous areas. The installation conditions and connection values indicated in these
instructions must be followed.
2.3 Operational safety
‣
Operate the device in proper technical condition and fail-safe condition only.
‣
The operator is responsible for interference-free operation of the device.
To Next Page
Loading...
