Endress+Hauser iTEMP TMT112 - Page 17

iTEMP TMT112 Commissioning
Endress+Hauser 17
Descriptor
Note!
The black highlighted function fields
are marking the Quick Setup menu.
Int.
temperature
Filter
time
RJ mode
RJ
external value
Bias input
Num resp
preams
Matrix
parameter
Device
data
HART
Output
AO
PV
Tag
number
Poll
addr
Message
Sensor
input
PV
Measuring
unit
Direction
output
Min measurm
range
Max
measurm
range
RTD
connection
RTD 2 wire
comp.
Sensor
error
Burst
mode
Burst
option
Date
Error
code
Last
diagnostic
Min
Indication
Max
Indication
Default
values
Simulation
cur.
Output
current
Security
locking
Coefficient X0
Coefficient X1
Coefficient X2
Coefficient X3
Coefficient X4
Dev Id
Product
revision
Hardware
rev
Universal
rev
Software
rev
Working
parameters
Calibration
Service
User
linearisation
!
A0040284-EN
 5 HART® function matrix
7.2.2 Configuration using HART® protocol and PC configuration software
The configuration of the transmitter can be done using both the HART® protocol and the PC
configuration software. The following table shows the structure of the interactive menu led
operation of the PC configuration software.
Configurable parameters (Unit function description see “Description of unit functions” on →  18
Standard settings • Sensortype
• Connection mode (2-,3-, or 4-wire connection on RTD)
• Units (°C, °F or K)
• Measurement range start value
• Measurement range end value
• Coefficient X0 to X4 (on sensor type polynom RTD/TC)
• Temp.-compensation (on sensor type polynom TC)
Expanded settings • Cold junction compensation internal/external (on TC)
• external temperature (on TC with cold junction compensation external)
• Cable resistance compensation (on RTD 2-wire connection)
• Fault condition reaction
• Output (4 to 20 mA/20 to 4 mA)
• Damping (filter)
• Offset
• TAG (Measurement point description)
• Descriptor
Service functions • Output simulation (on/off)
• Reset to default
• Series number (only display)
• Operation code (=release code 281)