Endress+Hauser iTEMP TMT112 - Page 21

iTEMP TMT112 Commissioning
Endress+Hauser 21
Min indication Display the minimum process value. The process value is accepted at the beginning of the
measurement.

Min. process value will be changed to the actual process value on access. On reset to
factory default, the default value is entered.
+10000
Max indication Display the maximum process value. The process value is accepted at the beginning of the
measurement.

Max. process value will be changed to the actual process value on access. On reset to
factory default, the default value is entered.
-10000
Default values Entry: 182 (Reset to factory default settings)
0
Output simulation
Simulation mode
Entry of simulation mode.
Entry: Off
On
Off
Output current
Simulation value
Entry of simulation value (current).
Entry: 3.58 to 21.7 mA
Keycode
Security locking
Release code for setting up.
Entry: Lock = 0
Release = 281
281
Tag
Tag number
Entry and display of measurement point description (TAG).
Entry: 8 characters
-
Descriptor Entry and display of plant description.
Entry: 16 characters
-
Dev ID Display of device generation
Software rev Display of software version
e.g.: 11 indicates version 1.1
Product rev Display of unit version
e.g.: 1.0000 indicates version 1.00.00
1) Not for thermocouples (TC)
7.2.4 Supported HART® commands
No. Description Access
Universal Commands
00 Read unique identifier r
01 Read primary variable r
02 Read p.v. current and percent of range r