EasyManua.ls Logo

Endress+Hauser iTEMP TMT84 - Operating Options

Endress+Hauser iTEMP TMT84
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TMT84 Operation
Endress+Hauser 23
5.3 Operating options
5.3.1 "FieldCare" operating program
FieldCare is Endress+Hauser's FDT-based Plant Asset Management Tool for the configuration and
diagnosis of intelligent field devices. Using status information, FieldCare serves as a simple but
effective tool for monitoring devices. Access to the iTEMP
®
TMT84 occurs exclusively via Profibus
communication.
!
Note!
More information:
to the operating structure see chapter 11.1
on the display of diagnostic information as per NAMUR NE107 Chap. 9.2.2
Detailed information on PROFIBUS
®
PA device parameterization and operation concept can be
found in the BA034S/04 Operating Instructions, “Guidelines for Planning and Commissioning
PROFIBUS
®
DP/PA - Field Communication” which can also be found on the CD-ROM. (Additional
sources: www.endress.com Download).
5.3.2 "SIMATIC PDM" operating program (Siemens)
SIMATIC PDM is a standardized, non-proprietary tool for the operation, configuration,
maintenance and diagnosis of intelligent field devices.
Further information at: www.endress.com
5.3.3 Current device description files
The following table lists the correct device description file for the relevant operating tool and the
source.
PROFIBUS PA protocol (IEC 61158-2, MBP):
Valid for firmware/software: 1.00.zz 1.01.zz See the DEVICE SOFTWARE parameter
PROFIBUS
®
PA device data
Profile version:
3.01 3.02 See the PROFILE VERSION parameter
TMT84 device ID:
Profile ID:
1551
hex
Depending on the profile GSD file
used: 0x9703, 0x9702, 0x9701
or 0x9700
See the DEVICE ID parameter
GSD information:
TMT84 GSD:
Profile GSD:
Bitmaps:
Extended
PA139700.gsd
PA139701.gsd
PA139702.gsd
PA139703.gsd
EH1551_D.bmp
EH1551_N.bmp
EH1551_S.bmp
Compatibility matrix:
| EH3x1551.gsd | EH021551.gsd
1.
00.zz |
OK | STOP*
1.01.zz | OK | OK
*Can be used if the "C1_Read_Write_supp
= 1" entry in the GSD is set to
"C1_Read_Write_supp = 0".
Operating program/device driver: Source for device descriptions/program updates, free downloads on
Internet:
GSD www.endress.com ( Download Software Device Drivers)
www.profibus.com
FieldCare/DTM www.endress.com ( Download Software Device Drivers)
SIMATIC PDM www.endress.com ( Download Software Device Drivers)
www.fielddevices.com

Other manuals for Endress+Hauser iTEMP TMT84

Related product manuals