Identification TMT84
6 Endress+Hauser
2 Identification
2.1 Device designation
2.1.1 Nameplate
The right device?
Compare and check the details on the device nameplate against the measuring point requirements.
a0009891
Fig. 1: Nameplate of the head transmitter (example, Ex version)
1 Power supply and extended order code
2 Serial number, device revision and firmware version
3 Approvals with symbols and 2D-barcode
4 2 lines for the TAG name
5 Approvals in hazardous area with number of the relevant Ex documentation (XA...)
6 Order code
2.2 Scope of delivery
The scope of delivery of the device comprises:
• Temperature head transmitter
• Securing material
• Multilingual hard copy of Brief Operating Instructions
• Operating Instructions and additional documentation on CD-ROM
• Additional documentation for devices that are suitable for use in hazardous areas (
0 2 1
),
such as Safety Instructions (XA...), Control or Installation Drawings (ZD...).
2.3 Certificates and approvals
On leaving the factory, the device was in perfect condition from the point of view of safety. The
device complies with the standards EN 61 010-1 "Protection Measures for Electrical Equipment for
Measurement, Control, Regulation and Laboratory Procedures" and with the EMC requirements of
IEC/EN 61326.
2.3.1 CE mark, declaration of conformity
The device meets the legal requirements of EU Directives. The manufacturer confirms a positive
completion of all tests by fitting the unit with a CE mark.
1
2
3
4
5
II3G Ex nA II T6/T5/T4 Ta= -40 ...+ 55/70/85°C
II3G Ex nL IIC T6/T5/T4 Ta= -40 ... +55/70/85°C
EH 08.001X
FNICO Apparatus
12345678910
Install per XA073/09/a3/01.08
9-32V
Suitable for Zone 22 when
install per XA074/09/a3/XX.XX
EH 08.002X
II3D Ex tD A22 IP54 T120°C
Made in Germany 2011
D-87484 Nesselwang
Ser.no.:
FW: X.XX.XX-[XXXXXXX
]
Input:
12345678ABCDEFGH
12345678ABCDEFGH
PROF I
BUS
PROCESS FIELDBUS
®
Profile: 3.02
iTEMP
®
TMT84-XXXXX/XX
2Dev.Rev.:
Ext. ord. cd.: XXXXX#
6
To Next Page
Loading...
