11 Operation using PROFIBUS
®
PA TMT84
88 Endress + Hauser
n: Number of the Transducer Block (1-2) or the sensor input (1 or 2).
11.4 Slot/Index lists
11.4.1 General explanatory remarks
Abbreviations used in the Slot/Index lists:
• Endress+Hauser matrix The number of the page on which you will find the explanation of the
parameter.
Object Type:
–Record Contains data structures (DS)
–Simple Contains only single data types (e.g. float, integer, etc.)
• Parameters:
–M Mandatory parameter
–O Optional parameter
• Data Types:
–DS Data structure, contains data types such as Unsigned8, Octet String, etc.
–Float IEEE 754 format
– Integer 8 (range of values -128 to 127), 16 (-327678 to 327678), 32 (-2
31
to 2
31
)
–Octet String Binary coded
– Unsigned 8 (range of values 0 to 255), 16 (0 to 65535), 32 (0 to 4294967295)
– Visible String ISO 646, ISO 2375
• Storage Class:
–C Calibration data
–Cst Constant parameter
–D Dynamic parameter
–N Nonvolatile parameter. Changing a parameter in this class does not affect the ST_REV
parameter of the block in question
–S Static parameter. Changing a parameter in this class increases the ST_REV parameter of
the block in question
–V Storage class V means that the altered parameter value is not saved in the device.
RJ temperature -
Quality
read Displays the quality (measured value status) of the inter-
nal reference temperature.
For value, see "PV value n - Quality"
RJ temperature -
Status
read Displays the status (measured value status) of the internal
reference temperature.
For value, see "PV value n - Status"
Sensor raw value n read Displays the non-linearized mV/Ohm of the relevant sen-
sor.
Measured values
Menu item Parameter
"Diagnostics"
Submenu
"Measured values"
Name
Parame-
ter access
Description
To Next Page
Loading...
