Commissioning Levelflex M FMP41C with HART/4...20 mA
54 Endress + Hauser
Exiting the navigation
•Press
F
again to run through the different modes of the envelope curve navigation.
•Press
O
and
S
to exit the navigation. The set increases and shifts are retained. Only when you
reactivate the "recording curve"(0E2) function does the Levelflex use the standard display
again.
6.8 Basic Setup with the ToF Tool
To carry out the basic setup with the ToF Tool operating program, proceed as follows:
• Start the ToF Tool operating program and establish a connection
• Select the "basic setup" function group in the navigation bar
The following display appears on the screen:
Basic Setup step 1/6:
• Status image
• Enter the measuring point description (TAG number).
L00-FMP4xxxx-20-00-00-en-001
!
Note!
• Each parameter that is changed must be confirmed with the RETURN key!
•The "Next" button moves you to the next screen display:
⇒
⇓
After 3 s, the following message appears
ENDRESS + HAUSER
E
+
–
To Next Page
Loading...
