Levelflex M FMP40 and FMP45 Technical data
69
Process pressure limits FMP40
All models: Vacuum (-1)...40 bar.
Note!
All Levelflex probes have two levels of sealing. There is an O-ring seal and a moulded seal behind
that.
FMP45
See pressure/temperature diagram on this page.
Materials in contact with
process
FMP40
• O-ring seal: see "Ordering structure" on Page 6 ff..
• Rope coating: PA 12 (Vestamid L 1940).
• All probes with 1½" and flange connection:
– on the lower edge of the process connections: PTFE (Dyneon TFM 1600).
• all Probes with ¾" connection:
– lower edge of the process connections: PPS-GF 40.
FMP45
Part Materials
1 Proczess connection
and rod probe or
rope
See "Ordering structure" on
Page 6 ff..
2 Feed-trough rod 1.44462, Duplex Cr22
3 NordLock washers 1.4547
4Centering stars PFA
Part Materials
1 Process connection
and rod probe or
rope
See "Ordering structure" on
→ Seite 6 ff..
2 Feed-trough rod Alloy C22 / 2.4602
3 NordLock washers 1.4547
4Centering stars PFA
14
1
2
3
14
1
2
3
To Next Page
Loading...
