CM42-MAA101EBE00 Accessories
Endress+Hauser 35
5. Push the two removal aids on the module in the direction of the DIN rail until the stop. This
locks the module onto the DIN rail.
6. Connect the cables in accordance with the wiring diagram (see "Wiring").
7. Connect the sensor, close the housing, and check that the entire measuring system is
working correctly.
5.2.2 Hardware and software required to change a parameter
To change the measured variable, you might require another input module.
The table lists the order numbers.
5.3 Return
The product must be returned if it is in need of repair or a factory calibration, or if the wrong
product was ordered or delivered. Legal specifications require Endress+Hauser as an
ISO-certified company, to follow certain procedures when handling products that are in contact
with the medium.
To ensure your device is returned in a safe, professional and swift manner,
check the website for information about the return procedure and basic conditions:
www.services.endress.com/return-material
5.4 Disposal
The device contains electronic components and must therefore be disposed of in accordance
with regulations on the disposal of electronic waste.
Please observe local regulations.
6 Accessories
The most important accessories available at the time this document went to print are listed
below. Contact your sales center or the service department for accessories that are not
listed here.
Changing the measured variable to:
pH
Analog
pH/ORP
Memosens
pH ISFET
Memosens
Conductive
conductivity
Analog
Inductive
conductivity
Analog
Conductivity
Memosens
Oxygen
Memosens
51518004 - - 51518005 51518006 - -
To Next Page
Loading...
