Diagnostics, troubleshooting CM42-MAA101EBE00
26 Endress+Hauser
3.9 Change sensor
You can use this function to change a similar sensor without restarting the device.
The device recognizes the type of sensor connected.
Furthermore, it is possible to distinguish between sensors based on their sensor name or sensor
group.
1. Select "Proceed sensor change (hold will be active)".
The sensor change automatically activates a hold. An error is not output at the
control system.
Depending on whether you assigned, or did not assign, a sensor name or sensor group in the
"SETUP/General settings/Sensor check" menu, you also receive information on the sensor
expected by the device.
2. Follow the instructions.
Factory default Options
•Abort action
•Factory default
Factory setting
Abort action
The device is restarted and all the customer-specific
settings are reset to the factory default values.
Cust. fact. default Options
•Abort action
• Cust. fact. default
Factory setting
Abort action
The device is restarted and all the settings are reset to
the original, optionally ordered settings
Path: DIAG / Service
Function Display Info
To Next Page
Loading...
