Design Micropilot FMR62
8 Endress+Hauser
3 Design
3.1 Permitted device types
The details pertaining to functional safety in this manual relate to the device versions
listed below and are valid as of the specified firmware and hardware versions.
Unless otherwise specified, all subsequent versions can also be used for safety functions.
A modification process according to IEC 61508 is applied for any device modifications.
Any exemptions from possible combinations of features are saved in the Endress
+Hauser ordering system.
Valid device versions for safety-related use:
3.1.1 Order codes
Feature: 010 "Approval"
Version: all
Feature: 020 "Power supply; output"
Version:
• A: 2-wire; 4-20 mA HART
• B
1)
: 2-wire; 4-20 mA HART, switch output
• C
2)
: 2-wire; 4-20 mA HART, 4-20 mA
• K: 4-wire; 90-253 VAC; 4-20 mA HART
Feature: 030 "Display; operation"
Version: all
Feature: 040 "Housing"
Version: all
Feature: 050 "Electrical connection"
Version: all
Feature: 070 "Antenna"
Version: all
Feature: 090 "Seal"
Version: all
Feature: 100 "Process connection"
Version: all
Feature: 500 "Additional operating languages"
Version: all
Feature: 540 "Application package"
Version: all
Feature: 550 "Calibration"
Version: all
Feature: 570 "Service"
Version: all
Feature: 580 "Test; certificate"
Version: all
1) In this version with one current output and one switch output, only the current output (terminals 1 and 2) is approved for safety functions. The
switch output can, if necessary, be wired for non-safety-oriented purposes.
2) In this version with two current outputs, only the first output (terminals 1 and 2) is approved for safety functions. The second output can, if
necessary, be wired for non-safety-oriented purposes.
To Next Page
Loading...
