Endress+Hauser Micropilot FMR67 - Customer-Specific Configuration; Services

Micropilot FMR67
Endress+Hauser V. 1, Rev. 3, 11-04-2017 67
Customer-specific
configuration
If the option IJ: "Customized parameterization HART", IK "Customized parameterization PA" or IL
"Customized parameterization FF" has been selected in feature 570 "Service", presettings that differ
from the default settings can be selected for the following parameters:
Parameters Communication
protocol
Picklist / range of values
Setup → Unit of length • HART
•
PA
• FF
• in
• ft
• mm
• m
Setup → Empty calibration • HART
• PA
• FF
max. 70 m (230 ft)
Setup → Full calibration • HART
• PA
• FF
max. <70 m (230 ft)
Setup → Extended setup → Curr. output 1 or 2 → Damping HART 0 to 999.9 s
Setup → Extended setup → Curr. output 1 or 2 → Failure
mode
HART • Min
• Max
• Last valid value
Expert → Comm. → HART config. → Burst mode HART • Off
• On
Services
The following services can be selected via the product structure in the Product Configurator
10)
:
• PWIS-free (PWIS = paint-wetting impairment substances)
• Customized parameterization HART →  67
• Customized parameterization PA →  67
• Customized parameterization FF →  67
• W/o tooling DVD (FieldCare)
• Hard-copy product documentation
10) Feature 570 in the product structure