Micropilot FMR67
Endress+Hauser V. 1, Rev. 3, 11-04-2017 61
CRN approval
Some device versions have CRN approval. Devices are CRN approved if the following two conditions
are met:
•
The device has a CSA approval (product structure: feature 010 "Approval")
• The device has a CRN-approved process connection as per the following table:
Feature 100 in the product structure Process connection
AGJ NPS 3" Cl.150 RF, 316/316L
AHJ NPS 4" Cl.150 RF, 316/316L
RGJ Thread ANSI MNPT1-1/2, 316L
• Process connections that do not have CRN approval are not listed in this table.
•
Please refer to the product structure to discover which process connections are available for a
specific device type.
• CRN-approved devices bear the registration number (tbd.) on the nameplate.
An additional pressure restriction applies for the device versions listed in the table below if they
are CRN-approved. The pressure range indicated in the "Process" section
→ 37 continues to
apply for device versions not listed in the table below.
Table, in preparation
To Next Page
Loading...
