Endress+Hauser Micropilot FMR67 - Process; Process Temperature, Process Pressure

Micropilot FMR67
Endress+Hauser V. 1, Rev. 3, 11-04-2017 37
Process
Process temperature, process
pressure
The pressure ranges indicated can be reduced by the choice of process connection. The nominal
pressure (PN) indicated on the nameplate refers to a reference temperature of 20 °C, and of
100 °F
for ASME flanges. Observe pressure-temperature dependency.
Please refer to the following standards for the pressure values permitted at higher
temperatures:
• EN 1092-1: 2001 Tab. 18
In terms of their stability-temperature property, the materials 1.4435 and 1.4404 are
grouped in EN 1092-1 table 18 under 13E0. The chemical composition of the two materials
can be identical.
• ASME B 16.5a – 1998 Tab. 2-2.2 F316
• ASME B 16.5a – 1998 Tab. 2.3.8 N10276
• JIS B 2220
FMR67, Drip-off antenna, PTFE DN50
p
-40
(-40)
+80
(+176)
0
(+32)
T
p
[°C]
([°F])
[bar] ([psi])
3 (43.5)
16 (232)
-1 (-14.5)
0 (0)
A0032186

13 FMR67: Permitted range for process temperature and process pressure, Drip-off antenna, PTFE DN50
1 Process connection: flange PP
2 Process connection: thread, flange 316L
FMR67, Drip-off antenna, PTFE DN50
Feature 100 "Process connection" Process temperature range Process pressure range
• GGJ:
Thread ISO228 G1-1/2
•
RGJ:
Thread ANSI MNPT1-1/2
–40 to +80 °C (–40 to +176 °F)
p
rel
= –1 to 16 bar (–14.5 to 232 psi)
p
abs
< 17 bar (246 psi)
1)
• XJJ:
UNI flange 3"/DN80/80A, 316L
• XKJ:
UNI flange 4"/DN100/100A, 316L
• XLJ:
UNI flange 6"/DN150/150A, 316L
• XJG:
UNI flange 3"/DN80/80A, PP
• XKG:
UNI flange 4"/DN100/100A, PP
• XLG:
UNI flange 6"/DN150/150A, PP
p
rel
= –1 to 3 bar (–14.5 to 43.5 psi)
p
abs
< 4 bar (58 psi)
1) The pressure range may be further restricted in the event of a CRN approval