Endress+Hauser Proline 200 - 8.2 Switching on the measuring device; 8.3 Setting the operating language; 8.4 Configuring the measuring device

Flowmeter Proline 200 PROFINET with Ethernet-APL Commissioning
Endress+Hauser 39
8.2 Switching on the measuring device
‣
After a successful function check, switch on the measuring device.
 After a successful startup, the local display switches automatically from the startup
display to the operational display.
If nothing appears on the local display or a diagnostic message is displayed, refer to the
Operating Instructions for the device →  3
8.3 Setting the operating language
Factory setting: English or ordered local language
X X X X X X XX X
20.50
Operation
Setup
Main menu
0104-1
Display language
English
Español
Français
Display language
English
Deutsch
Ã
0104-1
Ã
Español
Français
Display language
English
Deutsch
0104-1
Betrieb
Setup
Hauptmenü
Sprache
Deutsch
0104-1
XXXX
1.
2.
3.
4.
A0029420
 10 Taking the example of the local display
8.4 Configuring the measuring device
The Setup menu with its System units submenu and various guided wizards enable fast
commissioning of the measuring device.