Endress+Hauser Proline Prosonic Flow 93 Brief Operating Instructions

Installation Proline Prosonic Flow 93
26 Endress+Hauser
10. Screw the connecting cable into the individual sensor.
A0001112
Fig. 20: Mounting the sensor and connecting the connecting cable
This completes the mounting process. The sensors can now be connected to the transmitter via
the connecting cables  ä 30.
3.11 Installing Prosonic Flow W (Clamp-on)
3.11.1 Installation for measurement via one traverse
!
Note!
The procedure is like that for Prosonic Flow P (DN 50 to 4000 / 2 to 160")  ä 21.
3.11.2 Installation for measurement via two traverses
Prerequisites
• The installation distance (position sensor) is known  ä 8.
• The strapping bands are already mounted  ä 16/ ä 17.
Material
The following material is needed for mounting:
• Two strapping bands incl. mounting bolts and centering plates where necessary (already
mounted)
• A mounting rail to position the strapping bands
• Two mounting rail holders
• Two sensor holders
• Coupling fluid for an acoustic connection between the sensor and pipe
• Two sensors incl. connecting cables.

Endress+Hauser Proline Prosonic Flow 93 Specifications

General

Brand	Endress+Hauser
Model	Proline Prosonic Flow 93
Category	Measuring Instruments
Language	English