Proline Prosonic Flow 93 Hardware and software settings
Endress+Hauser
29
3.12 Post-installation check
• Are cables or the device damaged (visual inspection)?
• Does the device correspond to specifications at the measuring point, including process
temperature and pressure, ambient temperature, minimum fluid conductivity, measuring
range, etc.?
• Are the measuring point number and labeling correct (visual inspection)?
• Have the inlet and outlet runs been observed?
• Is the measuring device protected against moisture and direct sunlight?
4 Hardware and software settings
Diverse hardware and software settings are possible or necessary (e.g. device address
configuration) for measuring devices with PROFIBUS DP or FOUNDATION Fieldbus type of
communication. For a description of the possible settings and the exact procedure that applies
for the different types of communication, see the associated Operating Instructions on the CD.
To Next Page
Loading...
Need help?
General
