Endress+Hauser Proline Prosonic Flow B 200 - Page 55

Proline Prosonic Flow B 200 HART System integration
Endress+Hauser 55
Parameter Description Selection / User entry Factory setting
Burst variable 0 For HART command 9 and 33, assign a
HART device variable or process variable to
burst variable.
• Volume flow
• Mass flow
• Energy flow
• Methane fraction
• Calorific value
• Wobbe index
• Corrected volume flow
• Corrected methane volume
flow
• Temperature
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Pressure
• Sound velocity
• Flow velocity
• Signal asymmetry
*
• Acceptance rate
*
• Turbulence
*
• Signal strength
*
• Signal to noise ratio
*
• Percent Of Range
• Measured current
• Primary variable (PV)
• Secondary variable (SV)
• Tertiary variable (TV)
• Quaternary variable (QV)
• Not used
Volume flow
Burst variable 1 For HART command 9 and 33, assign a
HART device variable or process variable to
burst variable.
See Burst variable 0
parameter.
Not used
Burst variable 2 For HART command 9 and 33, assign a
HART device variable or process variable to
burst variable.
See Burst variable 0
parameter.
Not used
Burst variable 3 For HART command 9 and 33, assign a
HART device variable or process variable to
burst variable.
See Burst variable 0
parameter.
Not used
Burst variable 4 For HART command 33, assign a HART
device variable or process variable to burst
variable.
See Burst variable 0
parameter.
Not used
Burst variable 5 For HART command 33, assign a HART
device variable or process variable to burst
variable.
See Burst variable 0
parameter.
Not used
Burst variable 6 For HART command 33, assign a HART
device variable or process variable to burst
variable.
See Burst variable 0
parameter.
Not used
Burst variable 7 For HART command 33, assign a HART
device variable or process variable to burst
variable.
See Burst variable 0
parameter.
Not used
Burst trigger mode Select the event that triggers burst message
X.
• Continuous
• Window
• Rising
• Falling
• On change
Continuous
Burst trigger level Enter the burst trigger value.
Together with the option selected in the
Burst trigger mode parameter the burst
trigger value determines the time of burst
message X.
Positive floating-point number –