Technical data Proline Prosonic Flow B 200 HART
134 Endress+Hauser
Frequency output
Failure mode Choose from:
• Actual value
• 0 Hz
• Defined value: 0 to 1 250 Hz
Switch output
Failure mode Choose from:
• Current status
• Open
• Closed
Local display
Plain text display With information on cause and remedial measures
Backlight Additionally for device version with SD03 local display: red lighting indicates a
device error.
Status signal as per NAMUR recommendation NE 107
Operating tool
• Via digital communication:
HART protocol
• Via service interface
Plain text display With information on cause and remedial measures
Load → 26
Low flow cut off The switch points for low flow cut off are user-selectable.
Galvanic isolation All outputs are galvanically isolated from one another.
Protocol-specific data HART
• For information on the device description files → 52
• For information on the dynamic variables and measured variables (HART device
variables) → 52
16.5 Power supply
Terminal assignment → 25
Supply voltage Transmitter
An external power supply is required for each output.
The following supply voltage values apply for the outputs available:
To Next Page
Loading...
