Endress+Hauser Proline Prosonic Flow B 200 - Page 60

Commissioning Proline Prosonic Flow B 200 HART
60 Endress+Hauser
Parameter overview with brief description
Parameter Prerequsite Description Selection Factory setting
Volume flow unit – Select volume flow unit.
Result
The selected unit applies for:
• Output
• Low flow cut off
• Simulation process variable
Unit choose list Country-specific:
• m³/h
• ft³/min
Volume unit – Select volume unit. Unit choose list Country-specific:
• m³
• ft³
Corrected volume flow unit – Select corrected volume flow
unit.
Result
The selected unit applies for:
• Corrected volume flow
• Corrected methane volume
flow
Unit choose list Country-specific:
• Nm³/h
• Sft³/h
Corrected volume unit – Select corrected volume unit. Unit choose list Country-specific:
• Nm³
• Sft³
Mass flow unit – Select mass flow unit.
Result
The selected unit applies for:
• Output
• Low flow cut off
• Simulation process variable
Unit choose list Country-specific:
• kg/h
• lb/min
Mass unit – Select mass unit. Unit choose list Country-specific:
• kg
• lb
Temperature unit – Select temperature unit.
Result
The selected unit applies for:
• Temperature
• Maximum value
• Minimum value
• Average value
• Maximum value
• Minimum value
• Process temperature
• Maximum value
• Minimum value
Unit choose list Country-specific:
• °C
• °F
Pressure unit – Select process pressure unit.
Result
The unit is taken from:
• Failure value
• Measured values
• 4 mA value
• 20 mA value
• Failure value
• Maximum value
• Atmospheric pressure
• Pressure value
• Process pressure (5640)
Unit choose list Country-specific:
• mbar a
• psi a
Energy flow unit – Select energy flow unit.
Result
The selected unit applies for:
• Outputs
• Low flow cut off
Unit choose list Country-specific:
• kW
• Btu/h