Endress+Hauser Proline Prosonic Flow B 200 - Page 65

Proline Prosonic Flow B 200 HART Commissioning
Endress+Hauser 65
10.4.5 Configuring the current output
The "Current output 1 to 2" wizard guides you systematically through all the parameters
that have to be set for configuring the specific current output.
Navigation
"Setup" menu → Current output 1 to 2
Structure of the wizard
Volume flow
Assign curr.
Correct.vol.flow
Corr CH4 volflow
Mass flow
Ref. conditions
Current span
4...20 mA
NAMUR
4...20 mA US 4...20 mA
Fixed current
4 mA value
20 mA value
Failure mode
Defined value
Min. …
Failure current
End of wizard
Off*
A0015986-EN
 18 "Current output 1 to 2" wizard in the "Setup" menu (part 1)
Off* = Option only for current output 2