Endress+Hauser Proline Prosonic Flow B 200 - Page 88

Commissioning Proline Prosonic Flow B 200 HART
88 Endress+Hauser
Parameter overview with brief description
Parameter Prerequsite Description Selection / User
entry
Factory setting
Format display A local display is provided. Select how measured values
are shown on the display.
• 1 value, max. size
• 1 bargraph + 1
value
• 2 values
• 1 value large + 2
values
• 4 values
1 value, max. size
Value 1 display A local display is provided. Select the measured value that
is shown on the local display.
• Volume flow
• Corrected volume
flow
• Corrected methane
volume flow
*
• Mass flow
• Energy flow
*
• Methane fraction
*
• Calorific value
*
• Wobbe index
*
• Temperature
*
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Current output 1
• Current output 2
*
• Sound velocity
• Flow velocity
• Acceptance rate
*
• Signal asymmetry
*
• Turbulence
*
• Signal strength
*
• Signal to noise
ratio
*
Volume flow
0% bargraph value 1 A local display is provided. Enter 0% value for bar graph
display.
Signed floating-point
number
Country-specific:
• 0 m³/h
• 0 ft³/h
100% bargraph value 1 A local display is provided. Enter 100% value for bar
graph display.
Signed floating-point
number
Depends on country
and nominal
diameter
Decimal places 1 A measured value is specified
in the Value 1 display
parameter.
Select the number of decimal
places for the display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xx
Value 2 display A local display is provided. Select the measured value that
is shown on the local display.
Picklist see Value 1
display parameter
None
Decimal places 2 A measured value is specified
in the Value 2 display
parameter.
Select the number of decimal
places for the display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xx
Value 3 display A local display is provided. Select the measured value that
is shown on the local display.
Picklist see Value 1
display parameter
None
0% bargraph value 3 A selection has been made in
the Value 3 display
parameter.
Enter 0% value for bar graph
display.
Signed floating-point
number
Country-specific:
• 0 m³/h
• 0 ft³/h
100% bargraph value 3 An option was selected in the
Value 3 display parameter.
Enter 100% value for bar
graph display.
Signed floating-point
number
Depends on country
and nominal
diameter