Turbimax CUS71D Commissioning
Endress+Hauser 19
Path: Menu/Setup/Inputs/UIS/Extended Setup
The Refresh rate determines the time span to update
the current measurement. You can select 2, 4, 6, or 8
seconds.
Damping
This parameter establishes the number of updates that
are averaged to determine the current measurement. It
is used to remove the effects of random fluctuations
caused by settling or disturbed material. Also it
prevents sudden changes in the measurement resulting
from the action of rakes and skimmers.
Enter a value from 5 to 255.
You can adjust the parameters of the Sensor signal to
fit to the measuring point.
!
Note!
Before changing the parameter Sound speed contact
E+H service.
You can compensate the influence of the ambient
conditions to the sound speed.
To Next Page
Loading...
Need help?
General
