EnGenius ENH200EXT - Package Contents; System Requirement; Hardware Overview

1.3 Package Contents
Open the package carefully, and make sure that none of the items listed below are missing.
Do not discard the packing materials; in case of return, the unit must be shipped in its original
packaging.
 (1) Wireless Access Point / Client Bridge (ENH200EXT)
 (1) 24V/0.6A Power Adapter
 (1) PoE Injector (EPE-24R)
 (1) Pole Mount Kit
 (1) QIG
 (1) CD (User Manual)
Using a power adapter other than the one included with the ENH200EXT may
cause damage to the device.
1.4 System Requirement
The following conditions are the minimum system requirements.
 A computer with an Ethernet interface and operating under Windows XP, Vista, 7 or
Linux.
 An Internet browser that supports HTTP and JavaScript.
1.5 Hardware Overview
Physical Interface - 1 x Port with PoE support
- 1 x SMA Connector
- 1 x Reset
Maximum Wireless Data rate - 150 Mbps
LEDs status - Power Status
- LAN (10/100Mbps)
- WLAN (Wireless is enabled)
- 3 x Link Quality (Client Bridge mode)