EnGenius EnStation2 - Configuring Wireless LAN; Configuring Wireless Settings; Access Point Mode

4-22
B ASIC N ETWORK S ETTINGS
C ONFIGURING W IRELESS LAN
4.4 Configuring Wireless LAN
4.4.1 Configuring Wireless Settings
Below are the Instructions on how to configure the wireless and security settings for each of the possible operating modes:
WARNING!
Incorrectly changing these settings may cause the device to stop functioning. Do not modify the settings in this section without a
thorough understanding of the parameters.
Access Point Mode
The EnStation2 supports Access Point Mode. In this mode, users with a wireless client device within range can connect to the
EnStation2 to access the WLAN.
Wireless Mode
Wireless mode supports 802.11b/ g/n mixed
modes.
Channel HT Mode
The default channel bandwidth is 20/40 MHz. The
larger the channel, the better the transmission
quality and speed.
Extension Channel
Select upper or lower channel. Your
selection may affect the Auto Channel
function.
Channel / Frequency
Select the channel and frequency appropriate.
!