Enovation Controls Murphy PowerView PV485 User Manual

2021-0306-2507 7 00-02-1207
Introduction
The PV485 is a rugged CAN-based controller. This manual explains the functions and display
screens of the unit, describes the display screens and gives details about the PV485 Murphy
Standard Configuration.
Engine Parameters
The following are some of the 62109 possible engine parameters that can be displayed in
standard or metric units as well as in English, French, German, Spanish, Italian, Japanese,
Chinese, Portuguese, Russian and Czech languages.
• Coolant Level
• Fuel Level
• Alternator Voltage
• Oil Level
• System Voltage
• DEF Level
• Oil Pressure
• Coolant Temperature
• Battery Voltage
• Oil Temperature
•
Glossary of Terms and Acronyms
CAN – Controller Area Network
DM1 – Diagnostic Message 1, Active Diagnostic Trouble Codes
DM2 – Diagnostic Message 2, Previously Active Diagnostic Trouble Codes
DM4 – Freeze Frame Parameters
DPF – Diesel Particulate Filter
DTC – Diagnostic Trouble Code
ECU – Engine Control Unit
FMI – Failure Mode Identifier
PGN – Parameter Group Number
SPN – Suspect Parameter Number
Acronym/Term
Description
CAN
Controller Area Network
DM1
Diagnostic Message 1, Active Diagnostic Trouble Codes
DM2
Diagnostic Message 2, Previously Active Diagnostic Trouble Codes
DM4
Freeze Frame Parameters
DPF
Diesel Particulate Filter
DTC
Diagnostic Trouble Code
ECU
Engine Control Unit
FMI
Failure Mode Identifier
PGN
Parameter Group Number
SPN
Suspect Parameter Number
Formatted: Font: Italic, Font color: Red
Formatted Table
Formatted: Font color: Auto
Formatted: Bulleted + Level: 1 + Aligned at: 0 cm + Tab
after: 0.63 cm + Indent at: 0.63 cm
Formatted: Centered
Formatted Table
Formatted: Font: Bold
Formatted: Font: Bold

Enovation Controls Murphy PowerView PV485 Specifications

General

Brand	Enovation Controls
Model	Murphy PowerView PV485
Category	Monitor
Language	English